Jan 06, 2026 Leave a message

Precise Adjustment of Roller Pressure Parameters and Optimization of Fingerless Single Facer Machine Roller System Configuration

The roller system configuration and pressure control of the Fingerless Single Facer Machine are core technical aspects that determine the regularity of the corrugated flute profile and the bonding strength between the core paper and the linerboard. The precise setting of roller system parameters directly affects key indicators such as the edge crush strength and burst strength of the cardboard.

 

The Fingerless Single Facer Machine roller system mainly consists of three core components: the corrugating roller, the pressure roller, and the glue roller. The hardness matching, pressure setting, and gap adjustment of these three components must be precisely matched to the characteristics of the raw materials and the operating speed. In terms of roller material hardness, the corrugating roller should be made of high-strength alloy steel, with a hardness maintained in the HRC58-62 range, ensuring that the flute profile does not deform or wear under high-speed operation and high pressure; the hardness of the pressure roller material needs to be flexibly adjusted according to the core paper weight. When using high-strength core paper of 120-150g/㎡, the pressure roller hardness should be controlled at HS75-80 to avoid crushing the corrugated flute peaks due to excessive roller hardness, leading to a decrease in the cardboard's pressure resistance; if the core paper weight is less than 100g/㎡, a softer pressure roller with a hardness of HS65-70 should be used to ensure uniform pressure transmission and prevent defects such as tearing and wrinkling of the core paper.

Fingerless Single Facer Machine

The roller pressure setting is a key aspect of Fingerless Single Facer Machine roller system control. The linear pressure between the corrugating roller and the pressure roller needs to be dynamically adjusted according to the production speed. When the speed is in the range of 80-120m/min, the linear pressure should be controlled at 0.8-1.2MPa, which can ensure sufficient formation of the corrugated core paper while avoiding flute collapse due to excessive pressure; the gap between the glue roller and the corrugating roller needs to be precisely controlled to within 0.05mm. A gap that is too large can lead to insufficient glue application, resulting in poor bonding between the core paper and the linerboard and delamination; a gap that is too small will cause excessive glue, resulting in excessive moisture content in the cardboard, increased drying difficulty, and susceptibility to warping and deformation. Furthermore, the parallelism calibration of the roller system is equally important. The axial parallelism of the corrugating rollers and pressure rollers must be checked and calibrated monthly using a laser leveling instrument, with the deviation controlled within 0.02 mm/m. This prevents uneven cardboard thickness across the width due to roller misalignment, which could affect subsequent printing registration accuracy.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry